ok, so i've decided the neck on this guitar is very healthy. it's pointing at about a 30 degree angle downwards, which is surprising given the issues with the bridge. but, it might mean the truss was pulled all the way down. i suspect i'll have to adjust it, but that's ok - i just didn't want to have to reset it.

i'll need to get strings on, first.

regarding the bridge and how the guitar was/is made, somebody on one of the forums suggested i shine on a flashlight through the holes to determine what's in there, and the results are kind of inconclusive - the action holes look like solid top (although the wood grain is still moving in the wrong direction), whereas the string holes have clear layers (two for a reinforced bridge plate and two for the top, itself). on top of that, the age of the wood is visibly different.

so, it seems like somebody tried to reinforce the plate from the bottom and may have done some surgery to the top, although it's hard to tell. that means i want to avoid shaving it further, and rather want to continue with the reinforcement as best as possible.

i want this to be an acoustic guitar for recording, but i need to convince myself it can handle the tension, first. so, i'm going to start by stringing it with ball wound classical strings and see what happens. can i even hit that 21st fret? if it holds tune and plays well, i'll have to decide whether i want to keep it as a classical or move to the next higher tension, which is probably some heritage-designed steel string guitars that run a little less than 100 lb. and, if that's not good enough, i can look at silk & bronze, if i think it's workable.

so, i'm going to need the following:

- two c-clamps

- a small sanding block

- some title bond wood glue

- some ball end classical strings

unfortunately, i need a nap.